Immersion heating for thermal store
An electric immersion heater is usually used for additional heating of water in
thermal store or buffer tank. The immersion heater keep the proper temperature in
thermal store thanks to a thermostat.
Immersion heater uses an inner G 6/4" thermal store thread. This thread is almost
on every thermal store, see table below.
Immersion heater compatibility
| Thermal store |
G 6/4" threads |
Location |
| LMG 0V |
Yes, 1 piece |
2/3 of height |
| LMG 1V |
Yes, 1 piece |
2/3 of height |
| LMG 2V/2V-Stainless steel |
Yes, 1 piece |
2/3 of height |
| LVT 0V |
Yes, 9 pieces |
whole length |
| LVT 1V |
Yes, 7 ks |
entire height |
| LVT 2V/2V-Stainless steel |
Yes, 5 ks |
entire height |
| LMT 0V + stainless steel coil up to 800l |
Yes, 1 piece |
in the middle |
| LMT 1V + stainless steel coil up to 800l |
Yes, 1 piece |
in the middle |
| LMT 2V + stainless steel coil down to 800l |
Yes, 1 piece |
in the middle |
| LMT 0V + stainless steel coil down to 1000l |
Yes, 3 pieces |
in the middle, bottom part |
| LMT 1V + stainless steel coil up tp 1000l |
Yes, 2 pieces |
in the middle, bottom part |
| LMT 2V + stainless steel coil up to 1000l |
Yes, 2 pieces |
in the middle, bottom part |
| LSX 0V |
top, bottom, middle part |
- |
| LSX 1V |
top, middle parts |
- |
| LSX 2V |
middle of the tank |
- |
| |
* The LMS thermal store has mentioned thread located at 2/3 of the height
of the cylinder. It may cause some problems while screwing them in. Especially
when the tank is small (500l, 800l) and the chosen stainless steel coil is a
bigger one.
|
